Metallurgy / Chemicals / Rubber & Plastics

Recently, domestic raw materials have risen, high temperature shutdowns, flood seasons approaching, maintenance shutdowns... these factors continue to impact some downstream manufacturers. Under this circumstance, everyone will inevitably focus on imported recycled pellets, but be careful, the following raw materials cannot be touched!

Recently, under the supervision of Dayaowan Customs, 16 tons of "foreign garbage" were returned and shipped out of the country at Dalian Dayaowan Port. The declared product of this ticket is "modified polyethylene particles" and the declared weight is 16 tons.

During the inspection, the customs officer found that the goods were black cylindrical particles, which were suspected of solid waste, and they immediately took samples and sent them for inspection. After identification, the identified sample is recycled plastic pellets from industrial sources and belongs to solid waste.

Customs reminds: The new "Solid Waste Law" has greatly increased the penalty for illegal importation of solid waste into the country, from the original fine of 50,000 to 500,000 to a fine of 500,000 to 5 million, the highest fine The increase has been tenfold. If the circumstances are serious, criminal responsibility will be investigated in accordance with the law. Offenders will bear heavier legal liabilities and higher costs of breaking the law.

Looking at the above case, are you as confused as the editor about how to judge solid waste? The editor has sorted out some difficulties in the identification of solid waste for you, and I hope it will be helpful to you!

Product (non-waste material) judgment

It is difficult to judge the primary products: NdFeB, SmCo, brass slag mud, polyethylene wax, crude nickel cobalt hydroxide, copper matte, by-product zinc oxide, iron ore, recycled plastic particles.

Source analysis is difficult, three nodes need to be clarified

What is the original material, what is the production process, and what is the non-waste?

Be sure to pay attention to the production process products of unknown origin

All kinds of sludge, by-products of unintentional production, residues from reaction, bottom slag, molten slag, spices.

Analysis of material properties is difficult

It's not a complete analysis of product characteristics, but grasp key indicators.

Waste processed products

Nickel slag is reported as nickel concentrate, mineral fertilizer, wool skin, residual anode carbon block, tire pyrolysis carbon black, and rubber.

Editor's Message:

Pay attention! Enterprises should carefully verify the conditions of imported goods to avoid losses caused by mistakenly importing foreign waste into my country's territory. At the same time, once an enterprise has a record of imported solid waste, it will greatly increase the difficulty of customs clearance for similar products. The customs will increase the probability of inspection and testing of the enterprise.